Integration of Ajax devices into third-party systems, services and devices.

Is it possible to use Ajax SpaceControl with third-party wired or wireless central units?

The Ajax wireless remote control can be connected to third-party wired or wireless central units through the ocBridge Plus and uartBridge receiver modules.

How can SpaceControl be configured when using wireless remote control together with the ocBridge receiver module?

Connect the receiver module to the radio remote control and assign buttons to the corresponding zones.

Is it possible to connect Ajax uartBridge to third-party smart home systems?

Yes, if the third-party system supports the UART data transfer interface and the communication protocol can be configured or programmed. To configure uartBridge, use the uartBridge communication protocol via the UART interface.

How must the third-party system be configured after connection to the uartBridge receiver module?

If you have problems configuring a third-party security device, please contact the manufacturer of this device.

What is the difference between uartBridge and ocBridge Plus?

UartBridge has no relay contact, but there is a bidirectional data transfer protocol via the UART interface. This allows you to retrieve information about each device (battery status, alarm signal, sensor status) and connect up to 85 devices (up to 45 devices with the "Lun-11 mod. 2" device).

What is the data transfer rate via the UART interface?

How to connect uartBridge with "Lun-11 mod. 2"?

„Lun-11 mod. 2“ sollte in der Firmware nicht niedriger als Version 57, Tastatur – Version 35 und höher, Konfigurator – nicht niedriger als Version 1.0.2.205 gesteckt werden. Verbinden Sie das 4-polige Kabel mit der UART-Schnittstelle und dem X3-Anschluss des Control Panels.

Which models of Lun devices can uartBridge be connected to?

How quickly can ocBridgePlus identify the loss of a detector?

Standardmäßig hat ocBridge Plus eine Abfragedauer (Frame) von 36 Sekunden und 40 nicht zustellbare Pings. Bei diesen Einstellungen erkennt ocBridge Plus den Verlust der Melder in ca. 24 Minuten. Um diesen Wert zu verringern, öffnen Sie den Konfigurator, stellen Sie eine Verbindung zu ocBridge Plus her, und nehmen Sie in den Einstellungen unter „Service Event Control“ auf der Registerkarte“Verbindungsverlust“ Änderungen im Feld „Anzahl der Durchgänge“ vor. Sie können den Abrufzeitraum (Frame) auch in der Registerkarte“Radio Anhänger“ ändern.

Is it possible to connect the detectors from other manufacturers to the Ajax hub?

Unfortunately, this is currently not possible as devices from other manufacturers use different frequencies and communication protocols.

Can a surveillance camera be connected to the Ajax security system?

You can connect any IP camera with RTSP protocol to the Ajax security system. In total, up to 10 cameras can be connected to the hub and up to 50 cameras to the Hub Plus. Dahua cameras and DVRs can be added by reading a QR code - similar to Ajax devices. Hikvision or Safire video surveillance systems can be added to the hub with just a few clicks. DVRs allow you to override the limit on the number of video surveillance devices connected to the hub: up to 10 for the Hub and up to 50 for the Hub Plus. The DVR is only one device, but many surveillance cameras can be connected to it. The videos from each surveillance camera are stored in the Ajax app.